We know that it is very important for the master to properly handle the connectors of low-voltage power cables and wires when doing hydropower projects in interior decoration, especially for many cables that must be immersed in water for a long time. Electricity produces safety risks, what are the solutions for cable connectors in water? Today, let’s listen to what the electrician has to say about the solutions to cable connectors in water. I look forward to helping you.
Treatment method 1: First wrap 3 layers of waterproof tape, then cover the heat-shrinkable sleeve, and then cover the outside with PVC pipe and fill the structure with adhesive. After the low-voltage power cable is finished and the head is fixed, the wire knots are tinned to solve the problem, which can remove the effect of free radicals and prevent the occurrence of burns due to poor contact. Of course, this is not a must, but it will undoubtedly be better if you do it. If it is not solved by hot tin, then when changing lanes, you can use a technical twist drill to wrap the wire tightly to 6 To 7 laps, which can also bring good results. If the master's skills are good, hand-made wraps are also okay.
Solution 2: It is solved by using network cable pliers, which are generally used when solving the disconnection. The method is to wrap the two wires together, then put the air-conditioning copper pipe on the connection, and then use the network cable pliers to clamp Tight, wrap the insulating layer of waterproof tape on it. The advantage of doing so is that the joint will be very strong and not easy to fall off.
Treatment method 3: It is to use the terminal block for wiring. This method is very suitable for multi-core wires, and it is also very convenient to replace the route in the middle and later stages, but the defects will also increase the cost of hydropower projects. Therefore, in the current interior decoration medium, or very rare. But there is no doubt that this is also a very standardized wire connection.
